Hi I wondered if anyone had any welding tools that I could borrow for a day, perhaps with a short ten minute crash course on how to use them?
I have this candle set that I bought several years ago. It was part of a set of hand made candle holders crafted by a local artist, and they were all on sale. I bought this one for £10, reduced from £50! Bargain..... (pics below) Sadly I never really got to use it properly because I went to live in Holland shortly thereafter, and when I came back the people I had entrusted to look after them (my artistically retarded parents) decided to have a clear out when I was away and threw out a part of the set that was too big to fit in any boxes.
So what I am looking to do is re-make the bit that is missing, which I think should not be too difficult as it was the simplest bit by design. The three conical bits that hold the candles fitted into a large metal ring with three small rings placed equidistantly round the edge to accommodate them, and the whole thing hung down from the ceiling via the chains.
I don't know what the material is, at a guess I would say some form of carbon steel. The material used to replace this section is not so important so long as it is not too heavy of course. So what I would be looking to do is either source some materials already the desired topology for the job, or buy/find some metal rods and bend them into the required shape myself, preferably at minimal cost.
I might also, if someone is willing to let me use some tools for longer, make some fixtures for placing the cones onto a wall as this is by far a more practical alternative.
Pics here, can't work out how to insert image. Image is either too big or it wont take me to the direct http address.
Front of House, garden etc.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests